Enromat® M6 Duplex

Enrobing

Enromat^® M6 Duplex

The ENROMAT^{^®}M6 DUPLEX leaves nothing to be desired in terms of effectiveness! It enables the parallel enrobing of two different masses in one line. Modularly expandable and equipped with all ENROMAT^® M6 enrobing components, it can be optimally adapted to your production requirements.

Would you like an on-site consultation? Send us a message - we will be happy to advise you.

The Enromat^® M6 Duplex consists of two completely separate enrobing systems. The enrobing stations, blowing and shaking units are adjusted separately.

Features

Modular expandable construction
External tempering for chocolate with two separate mass circuits
With the appropriate machine design, the percentage of the two coating masses (colours) can be variably adjusted
All enrobing components correspond to the Enromat^® M6

Working width [mm]	820 up to 2600
Length [m]	1,95 up to 3,00

Roller Curtain Trough

The roller curtain trough can be used instead of the curtain trough.

Strip Coating Device

The strip coating device can be used for partial coatings.

Hold-down roller

A hold-down roller enables the production of uniform "half-coatings" (bottom and side coating).

Wire belt hold-down device

A wire belt hold-down device is used for full coating (e.g. wafers, sandwich products).

Biscuit turning device

The biscuit turning device is used for turning bottom-coated products.

Roller bed

A roller bed enables the production of very thin bottom coatings.

Mass Change

In addition to a standard mass change with minimal mass mixing, which can be carried out easily due to the design, we offer the following solutions for special requirements.

Mass Change with cleaning

All SOLLICH enrobing machines with external temperature control are optionally designed for cleaning with water.

Mass Change "wheel-in/wheel-out" system (patented)

The patented "wheel-in/wheel-out" system is the fastest mass change procedure and allows a mass change in only 5 minutes with one operator.

Mass Change "Tandem system"

If you do not have space to slide one enrober out to the side the best solution is to have two enrobers in series to enable you to change from one mass to another as quickly as possible.