Sollcoater® SC / SCT

Enrobing

Sollcoater^® SC / SCT

The Sollcoater^® SC / SCT is the ideal type of machine in the middle performance range.

For all working widths, you can choose between the Sollcoater^® SCT with built-in turbo tempering and the Sollcoater^® SC with external Turbotemper^®e TE. It is also possible to use the machine without a temperature control unit for processing compound.

All machines are suitable for full, half and bottom coating.

Features

Designed to be easy to operate and clean
Chocolate takeaway when using built-in tempering up to 200 kg/h, in case of external tempering without capacity limitation
Gentle mass circulation through adjustable Sollich pawl pump
Uniform adjustable bottom bath through frequency controlled bottoming roller
Easy to reproduce double curtain station
Blow-off device with only +/- 1 % deviation over the working width
Effective mechanical shaking device
Detailer without any straps (patented) easily removable

Working width [mm]	520 up to 820
Length [m]	1,35

Roller Curtain Trough

The roller curtain trough can be used instead of the curtain trough.

Strip Coating Device

The strip coating device can be used for partial coatings.

Hold-down roller

A hold-down roller enables the production of uniform "half-coatings" (bottom and side coating).

Wire belt hold-down device

A wire belt hold-down device is used for full coating (e.g. wafers, sandwich products).

Biscuit turning device

The biscuit turning device is used for turning bottom-coated products.

Roller bed

A roller bed enables the production of very thin bottom coatings.

Mass Change

In addition to a standard mass change with minimal mass mixing, which can be carried out easily due to the design, we offer the following solutions for special requirements.

Mass Change with cleaning

All SOLLICH enrobing machines with external temperature control are optionally designed for cleaning with water.

Mass Change "wheel-in/wheel-out" system (patented)

The patented "wheel-in/wheel-out" system is the fastest mass change procedure and allows a mass change in only 5 minutes with one operator.

Mass Change "Tandem system"

If you do not have space to slide one enrober out to the side the best solution is to have two enrobers in series to enable you to change from one mass to another as quickly as possible.