Enromat® M6 CIP

Enrobing

Enromat^® M6 CIP

The Enromat^® M6 CIP is the first enrober that can be automatically completely washed and dried.

The CIP cleaning of the Enromat^® M6-CIP is done automatically with hot water. The integrated spray nozzles target the soiled areas in several rinsing cycles. The operator can adjust the sequence of the washing and drying process to suit individual needs. The specially developed hot water circulation system saves water and energy.

Features

CIP variant of the Enromat^® M6
Integrated wash trolley above the wire belt
Water circulation and treatment system with filter
Short washing and drying times
Spraying devices at all necessary points
All enrobing components correspond to the Enromat^® M6

Working width [mm]	820 bis 1800
Length [m]	1,95 bis 3,00
Other	Hot water 65 to 80°C by customer

Roller Curtain Trough

The roller curtain trough can be used instead of the curtain trough.

Strip Coating Device

The strip coating device can be used for partial coatings.

Hold-down roller

A hold-down roller enables the production of uniform "half-coatings" (bottom and side coating).

Wire belt hold-down device

A wire belt hold-down device is used for full coating (e.g. wafers, sandwich products).

Biscuit turning device

The biscuit turning device is used for turning bottom-coated products.

Roller bed

A roller bed enables the production of very thin bottom coatings.

Mass Change

In addition to a standard mass change with minimal mass mixing, which can be carried out easily due to the design, we offer the following solutions for special requirements.

Mass Change with cleaning

All SOLLICH enrobing machines with external temperature control are optionally designed for cleaning with water.

Mass Change "wheel-in/wheel-out" system (patented)

The patented "wheel-in/wheel-out" system is the fastest mass change procedure and allows a mass change in only 5 minutes with one operator.

Mass Change "Tandem system"

If you do not have space to slide one enrober out to the side the best solution is to have two enrobers in series to enable you to change from one mass to another as quickly as possible.