Enromat® M6 Magnum

Enrobing

Enromat^® M6 Magnum

High working speeds, even in multi-shift continuous operation - our high-performance system. The ENROMAT^{^®} M6 MAGNUM with its various coating components and modular design guarantees optimum conditions for perfect results. Do you have any questions? We will be happy to advise you.

Depending on requirements, the Enromat^® M6 Magnum is built as a high-performance version with machine lengths from 2.40 m to 8.00 m. Equipped with several enrobing stations, blow-off and shaking devices, this machine is specially designed for sophisticated products and to run at higher belt speeds over approx. 6 m/min.

Features

Modular expandable construction
Excellent accessibility
Can be equipped with several enrobing components according to the product requirements
All enrobing components correspond to the Enromat^® M6

Working width [mm]	820 up to 2600
Length [m]	von 2,40 up to 8,00

Roller Curtain Trough

The roller curtain trough can be used instead of the curtain trough.

Strip Coating Device

The strip coating device can be used for partial coatings.

Hold-down roller

A hold-down roller enables the production of uniform "half-coatings" (bottom and side coating).

Wire belt hold-down device

A wire belt hold-down device is used for full coating (e.g. wafers, sandwich products).

Biscuit turning device

The biscuit turning device is used for turning bottom-coated products.

Roller bed

A roller bed enables the production of very thin bottom coatings.

Mass Change

In addition to a standard mass change with minimal mass mixing, which can be carried out easily due to the design, we offer the following solutions for special requirements.

Mass Change with cleaning

All SOLLICH enrobing machines with external temperature control are optionally designed for cleaning with water.

Mass Change "wheel-in/wheel-out" system (patented)

The patented "wheel-in/wheel-out" system is the fastest mass change procedure and allows a mass change in only 5 minutes with one operator.

Mass Change "Tandem system"

If you do not have space to slide one enrober out to the side the best solution is to have two enrobers in series to enable you to change from one mass to another as quickly as possible.